dim strsql
'********************************************************************
' 读数据库相关操作
sub readdb()
strsql="select * from test"
rs.open strsql,conn,1,1
if rs.EOF then response.write "no record at all":exit sub
response.write ""
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""
next
response.write ""
while not rs.EOF
response.write ""
for i=0 to rs.Fields.Count-1
response.write ""
next
response.write ""
rs.MoveNext
wend
response.write "

"&rs.Fields(i).Name&"

"&rs.Fields(i).Value&"

"
rs.Close
end sub
'********************************************************************

'********************************************************************
' 写数据库相关
sub insertdata()
strsql="INSERT INTO test(name,age,addr) VALUES('"&name&"',"&age&",'"&addr&"')"
rs.Open strsql,conn,1,3
end sub
'********************************************************************

if mode=1 then
call insertdata()
response.write "insert ok!"
elseif mode=2 then
call readdb()
end if

'********************************************************************
' 释放数据库连接对象
set rs=nothing
set conn=nothing
%>

注意：要运行上述ACCESS例程请先下载数据库，放在rwdata文件夹下。请将例程放在根目录下。